![]() ![]() If you want to turn off / decommission your burglar alarm yourself, then follow the following video. If you want a professional engineer to fix your alarm system, get in touch with the SmartSecurity team. At this point your alarm is decommissioned. The bell will usually ring for 20 minutes and then stop. You can’t do anything about this – unless you get an engineer to do the full decommissioning for you. At this point the outside bell will start ringing. Mains Power Failure: If you have a power failure then until the power comes back on your alarm. To fix this requires you to change the system battery. Locate the battery inside of the alarm panel, and remove the x2 terminal wires – red and black. Low Battery: If your alarm has a low battery or a battery fault, then your alarm will beep intermittently and may also indicate a ‘battery fault’ on the panel via a light or a message. Now, open the front of your main alarm panel – by unscrewing the screws. ![]() Your alarm will now have no mains power going to it, and it will be running off the battery only. Remove the fuse from inside – by levering open the small compartment in the front of the box, and prizing the fuse out. Now locate the alarm fuse spur – this is usually located next to the alarm panel. If you don’t use your burglar alarm system or want to completely turn off the power to it, then you will need to do the following in order to turn the power of / decommission it:įirst locate your main alarm panel – this is normally a mid-sized white box attached to a wall. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |